I'm not sure if this is meant to be by design and it's not earth shattering, but it seems quirky behaviour to me.įrom poking around in widows registry and an assumption when you open the 'HWiNFO Fan Control' window it reads the registry key: HKEY_CURRENT_USER\SOFTWARE\HWiNFO64\Sensors\CustomLutFan1\Sensorīasically I'd assume if you click 'System Auto' or 'Set Manual' button that the Sensor registry key should be set to 00000000_0_-1, but it's not.Įither that or the 'System Auto' and 'Set Manual' buttons should be disabled while Custom Auto is active until ther user sets 'None / Off' under the Sensor dropdown. If Open the 'HWiNFO Fan Control' window again the 'Custom Auto' reports Active. If I set a 'Custom Auto' and then decide to click 'System Auto' at a later time without actually going back into 'Fan Control Look-up Table' window and setting Sensor to 'None / Off', then the GUI report the 'Custom Auto' as 'Inactive' as it should and I close the 'HWiNFO Fan Control' window. I'm using HWiNFO64 v3.93-1530 on my laptop just for the fan control feature but I think there's some things in the Fan Control GUI don't seem quite right. Hi and thank you greatly for HWiNFO fan control options.
